在线客服
企业微信
点击图片查看原图
[VIP第2年] 指数:2
通过认证 
| Photoelectric sensors | ||||||||||||||||||||||||||||||||||||||||
|
|
|||||||||||||||||||||||||||||||||||||||
| Features | |||
 |
Sensor/detection principle: | Through-beam photoelectric sensor | |
|
Dimensions (W x H x D): | 11 mm x 31 mm x 20 mm | |
|
Housing design (light emission): | Rectangular | |
|
Sensing range max.: | 0 m ... 15 m | |
|
Sensing range: | 0 m ... 12 m | |
|
Type of light: | Visible red light | |
|
Light source: | LED 1) | |
|
Wave length: | 680 nm | |
|
Angle of dispersion: | Ca. 7.2 ° | |
|
Focus adjustable: | - | |
|
Adjustment: | Potentiometer, 270 ° | |
|
Light spot size (distance): | Ø 1,500 mm (12 m) | |
|
1) Average service life of 100,000 h at TA = +25 °C | |
| Mechanics/electronics | |||
|
Supply voltage: | 10 V DC ... 30 V DC 1) | |
|
Residual ripple: | ± 10 % 2) | |
|
Power consumption, sender: | ≤ 15 mA 3) | |
|
Power consumption, receiver: | ≤ 20 mA 4) | |
|
Output type: | PNP, open collector | |
|
Switching mode: | Light/dark switching | |
|
Switching mode selector: | Manually selectable | |
|
Output current Imax.: | ≤ 100 mA | |
|
Response time: | ≤ 0.5 ms 5) | |
|
Switching frequency: | 1,000 Hz 6) | |
|
Angle of reception: | Ca. 15 ° | |
|
Connection type: | Cable, 3-wire, 2 m 7) | |
|
Cable material: | PVC | |
|
Conductor cross-section: | 0.18 mm² | |
|
Circuit protection: | A, B, D 8) 9) 10) | |
|
Weight: | 106 g | |
|
Polarisation filter: | - | |
|
Special device: | - | |
|
Optics material: | PMMA | |
|
Enclosure rating: | IP 65 | |
|
Ambient operating temperature: | -25 °C ... +55 °C | |
|
Ambient storage temperature: | -40 °C ... +70 °C | |
|
Signal voltage PNP HIGH/LOW: | UV - 1,8 V / ca. 0 V | |
|
Housing material: | ABS/PC/POM, Plastic | |
|
1) Limit values, operation in short-circuit protected network max. 8 A 2) May not exceed or fall short of VS tolerances 3) 4) Without load 5) Signal transit time with resistive load 6) With light/dark ratio 1:1 7) Do not bend below 0 °C 8) A = VS connections reverse-polarity protected 9) B = inputs and output reverse-polarity protected 10) D = outputs overcurrent and short-circuit protected |
